[Search for users] [Overall Top Noters] [List of all Conferences] [Download this site]

Conference irocz::common_brouters

Title:Digital Brouters Conference
Notice:New common-code brouter family: RouteAbout, DECswitch 900
Moderator:MARVIN::HARTLL
Created:Mon Jul 17 1995
Last Modified:Fri Jun 06 1997
Last Successful Update:Fri Jun 06 1997
Number of topics:929
Total number of notes:3736

737.0. "ISDN Dialup did not work" by TKOVOA::NAKANO_K (Koichi Nakano/NPB/Japan) Sun Feb 02 1997 03:43

I use two RouteAbout EIs to set ISDN Dialup connection each other. This ISDN 
is Japanese INS64 service. They worked fine under DRS V1.1(V1.12,V1.18) 
without "set any_inbound" command.

With DRS V2.0(2.0-1), they did not work. Could not connect each other. 
Only when connecting with issuing "set any_inbound" command.

Router configuration was quite the same, only difference was DRS version 
number.


Koichi
T.RTitleUserPersonal
Name		DateLines
737.1MARVIN::CLEVELANDMon Feb 03 1997 09:3412
    Can you post a trace of ISDN and GW events when the connection is being
    made?  Preferably for both cases (V1.1 and V2.0).
    
    If you need 'SET ANY' to get it to work, that means either the incoming
    calling party number (aka caller id) or the incoming local address
    don't match the destination set on the dial circuit.  'set any'
    disables this check.
    
    Also, what does the caller's dial circuit look like?  Specifically,
    does it have 'send line id' enabled?
    
    Tim
737.2Thank you!!TKOVOA::NAKANO_KKoichi Nakano/NPB/JapanSun Feb 09 1997 03:0016
Thank you, Tim.

>    Also, what does the caller's dial circuit look like?  Specifically,
>    does it have 'send line id' enabled?

Your pointing "Send Line ID" was disabled. After enable it, connect fine.

Default value of "SEND Line ID" and "Any Inbound" may be following. Right?

			SEND Line ID	Any Inbound	Connect
	V1.1		Yes(may be)	No		OK
	V2.0		No		No		NG


Koichi
737.3EDWIN::TACMon Feb 10 1997 08:1911
    In V1.1, Line ID was always sent.
    
    In V2.0, it is selectable; I'm not sure what the default is, or what
    value will be found on a existing dial circuit after an upgrade to V2. 
    I would hope in both cases it is enabled, to allow existing
    configurations to continue working!
    
    Any Inbound is never the default, because it should be used with care
    (both for security and operational reasons).
    
    Tim