| On that board, JP8 is a 5-pin connector containing both the keyboard
lock and power LED connectors. You probably need to jumper the
right-hand 2 pins if you don't have a keyboard lock switch on your
case.
The documentation on all of the connectors is poor, but especially on
JP12, 13, 14, 7, 8, and 20, which are all in a row at the front (card
slots at the back), and JP74, which is the middle 2 of 6 pins just in
front of the aluminum heatsink. Antec technical support was of no help
to me, but from experimentation they should be connected as follows
(all 2-pin connectors unless otherwise noted):
JP12 - front-panel reset switch
JP13 - (turbo switch - use unknown on this board)
JP14 - (turbo LED - presumably polarized, presumably on when in
turbo mode, but use unknown)
JP7 - 4 pins. speaker (the cheap little one that comes with the case)
Positions 1 and 4 are used.
JP8 - 5 pins. In theory, this could probably have been wired so that
it didn't make any difference how you plugged in a 3-pin and a
2-pin connector, but it doesn't seem to have been done that
way. Looking from the front (card slots along the back):
Positions 1 and 3 (from the left) - power LED.
Polarized.
Positions 4 and 5 - keyboard lock switch
This is intended to be connected to a key
switch. If you don't have one, these 2 pins should
be jumpered, I think. I believe that open is the
"locked" position. It could be the other way
though.
JP20 - IDE (disk activity) LED. Polarized.
JP74 - "Green" LED. Polarized. Lights to indicate that the
processor is in "doze", "standby", or "suspend" mode.
When you get to the BIOS setup screens, you may find it helpful to get
the description of the screens for Triton II boards from the Award WWW
site:
http://www.award.com/Docs/i82430hx.htm
There are some minor differences bewteen the full setup described on
that page and the specific setup on this board, but the descriptions
are far better, and they're in actual English. The power saving
timeouts are a little strange, however, even with better descriptions.
If you have any questions, feel free to send me e-mail.
-Tom
|