| Title: | DEChub/HUBwatch/PROBEwatch CONFERENCE |
| Notice: | Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7 |
| Moderator: | NETCAD::COLELLA DT |
| Created: | Wed Nov 13 1991 |
| Last Modified: | Fri Jun 06 1997 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 4455 |
| Total number of notes: | 16761 |
Folks Am I right in believing that the maximum number of communities that you are able to set for a DECagent 90 is only three? Or have I done something wrong? I was unable to create any more, and when I tried to delete one of the communities it di not allow me to do it. After I factory reset the agent it all appeared to work ok. Any ideas? Steven Freke [Posted by WWW Notes gateway]
| T.R | Title | User | Personal Name | Date | Lines |
|---|---|---|---|---|---|
| 3517.1 | Failing DECagent, bet your money. | BARNA::DSMAIL | Wed May 08 1996 06:27 | 18 | |
Last week I installed/configured a huge Hubwatch controlled network.
My susprise was when I discoverd that since firmware 3.0 of DECagent
the number of modules it could manage had been reduced from 64 to 48.
But the number of communities I set up were more than three, I
configured 15 HUB90 with a couple of DECagent90 and a DECbridge90 in
the rest of the hubs, the number of communities per agent were 6 or 7.
If you're running 3.0 or 3.1 of DECagent90 I would suspect of a failing
DECagent90 not allowing to set up more than 3 communities.
If you're running an unknown -for me- greater revision you should check
if the number of communities has been reduced.I don't think so.
Jordi Manchon
See note 3487
| |||||