| Title: | DEChub/HUBwatch/PROBEwatch CONFERENCE | 
| Notice: | Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7 | 
| Moderator: | NETCAD::COLELLA DT | 
| Created: | Wed Nov 13 1991 | 
| Last Modified: | Fri Jun 06 1997 | 
| Last Successful Update: | Fri Jun 06 1997 | 
| Number of topics: | 4455 | 
| Total number of notes: | 16761 | 
    I am installing a DECHUB 900 MultiSwitch with four DECconcentrator
    900MX. This is a standalone HUB which will have 6 AXP VMS machines
    attatched. We need to have a primary and a secondary FDDI ring on
    this setup. Being illiterate when it comes to the new network 
    equipment I would appreciate a pointer or two on how to setup the
    two rings. 
    
    I have gone through this notes file and there is a lot of information
    presented and I'm sure my answer is in there, but I can't understand
    half of what I am reading. 
    
    Thanks
    
    Bruce
| T.R | Title | User | Personal Name | Date | Lines | 
|---|---|---|---|---|---|
| 3267.1 | NETCAD::DOODY | Michael Doody | Mon Feb 12 1996 10:53 | 9 | |
|     You could start with the FDDI configuration guide in note # 2340.
    
    Not sure what you mean by primary and secondary. Perhaps you mean dual
    homing. In that case you'd connect all the concentrators together in
    a dual ring in the hub backplane with Hubwatch, then connect each port
    of the DAS on the workstations to a different concentrator, thus
    gaurding against a fault in any one concentrator or cable.
    
    -Mike
 | |||||
| 3267.2 | STRWRS::KOCH_P | It never hurts to ask... | Mon Feb 12 1996 15:04 | 6 | |
|     I agree with Michael in .1, but to really make it fault tolerant, put
    dual controllers in the AXP machines. Even with FDDI dual homing and
    N+1 power in the DEChub, the NIC card is still a single point of
    failure, regardless of whether it's a DAS card. DAS simply provides
    path redundancy, but two controllers along with items mentioned in .1
    provide total redundancy.
 | |||||
| 3267.3 | HUBwatch | FREEBE::B_ROSE | Tue Feb 13 1996 06:12 | 7 | |
|     It sounds as the HUBwatch software is required to set up the "dual"
    rings. I copied down the notes entry mentioned and will go through it
    before I try anything else. As for the second card .. it'd be nice, but
    we have gone almost two years without a "glitch" with the card in there
    so it'd be tough to sell them a second card.
    
    Bruce
 | |||||