|
> When I try to set my in band ip address throug the setup port on
> the DEChub 900MS (in redirect mode) the repeater comes back with the
> following message: " No more room in IP address table. IP address
> not set. "
Just to clarify - you were attempting to set the In-band address
_of_the_repeater_, having redirected the hub console to the repeater;
correct?
Did the Hub itself have an in-band address assigned, and was the
repeater in question the IP server?
> I tried to reset the repeater with "current settings" and also with
> the "Factory settings". No luck. Repeater response: " Module not
> responding ! Connection closed !"
That part I can explain. When you reset the repeater, it stops
communicating with the management module while it is running its
self-test. The "Module not responding..." comes from the hub
management module.
> Can anybody help me out.
That's what we're here for ! :-)
What version of the repeater firmware are you running (you can get this
from the "Show current settings" selection on the repeater setup menu)?
I'd recommend doing a factory reset on both the hub and the repeater
and try again to configure everything. Take notes about each step you
take - if you still have the problem, send us your notes and we'll try
to reproduce the problem here.
|