[Search for users] [Overall Top Noters] [List of all Conferences] [Download this site]

Conference netcad::hub_mgnt

Title:DEChub/HUBwatch/PROBEwatch CONFERENCE
Notice:Firmware -2, Doc -3, Power -4, HW kits -5, firm load -6&7
Moderator:NETCAD::COLELLADT
Created:Wed Nov 13 1991
Last Modified:Fri Jun 06 1997
Last Successful Update:Fri Jun 06 1997
Number of topics:4455
Total number of notes:16761

653.0. "MOP not available after DENMA upgrade ti T2.0" by KERNEL::LLOYDA (Don't worry... Be Happy ;^)) Mon Jan 24 1994 14:41

    Hi,
    
    I have just upgraded our DECagent 90 from V1.1 to T2.0.9 and now I
    cannot connect via MOP to the console of the agent.
    
    From a Phase V system I get the following,
    
    	$ set host/mop denma
    	%MOP-E-NOCON, console carrier not supported by remote system
    	$
    
    and from a Phase IV system I get...
    
    	NCP>conn via sva-0 phys addr 08-00-2B-2D-4A-ED
    	Target does not respond
    	NCP>
    
    Please note that the above commands return immediately, if I change the
    address on the Phase IV system (e.g. to 08-00-2b-ff-ff-ff) then it
    takes quite a while longer before timeing out.
    
    Also... should the agent see the 90l+'s that are in our hub, it only
    now picks up the DECbridge 90 and the DECrepeater 90C ?
    
    Alan Lloyd.
    CSC Basingstoke.
T.RTitleUserPersonal
Name		DateLines
653.1DECserver 90L+LEVERS::DRAGONTue Jan 25 1994 08:588
    
    Alan,
    
    	Some DECserver 90L+s are autodiscoverable (DECserver 90L++), while 
        other older revs are not. Those which are not autodiscoverable must
        be added via HUBwatch.
    
    Bob
653.21 down, 1 to go !!!KERNEL::LLOYDADon't worry... Be Happy ;^)Tue Jan 25 1994 09:337
    Bob,
    
    O.k. that explains why they aren't available.
    
    Now then.... why can't I connect via MOP ?
    
    Al.
653.3DECagent 90 never supported inbound MOPROGER::GAUDETBecause the Earth is 2/3 waterTue Jan 25 1994 10:106
You never could.  The DECagent 90 does not support inbound MOP connections.
The only way to get the console menu is to connect a terminal or modem.  If you
have succeeded at doing this in the past I would be very interested in how.

Roger Gaudet
DECagent 90 Development