Conference netcad::hub_mgnt

147.0. "First time clicking on bridge failure" by HANNAH::BUGSBY::COBB (Writing from ALPHA AXP) Thu Feb 04 1993 08:19

    
    
    When I bring up hubwatch for VMS T1.1.4 and click on the work group
    bridge, I get 
    
    ERROR: Failed to get IF interface
    
    If I click a second time, I get the detail window.
    
    This is consistent.  Below is the full output.
    
    $  MCR HUBWATCH  -x 16.122.128.50 -c public -a billc
    (W): NMS_DIR is not defined - using [.uid] directory
    (D):
    HUB CONFIGURATION:
    (I):
    ___________________________________________________________________________
    (D): Slots:     1       2       3       4       5       6       7      
    8
    (D): Cards:     Empty   Empty   Empty   DECMR   DS90L   DS90L   DEWGB  
    DENMA
    (I):
    ___________________________________________________________________________
    (D): Slot 5: Port 1:  status = DISCONNECTED (OFF)
    (D): Slot 5: Port 2:  status = DISCONNECTED (OFF)
    (D): Slot 5: Port 3:  status = DISCONNECTED (OFF)
    (D): Slot 5: Port 4:  status = DISCONNECTED (OFF)
    (D): Slot 5: Port 5:  status = DISCONNECTED (OFF)
    (D): Slot 5: Port 6:  status = DISCONNECTED (OFF)
    (D): Slot 5: Port 7:  status = DISCONNECTED (OFF)
    (D): Slot 5: Port 8:  status = DISCONNECTED (OFF)
    (D): Slot 6: Port 1:  status = DISCONNECTED (OFF)
    (D): Slot 6: Port 2:  status = DISCONNECTED (OFF)
    (D): Slot 6: Port 3:  status = DISCONNECTED (OFF)
    (D): Slot 6: Port 4:  status = DISCONNECTED (OFF)
    (D): Slot 6: Port 5:  status = DISCONNECTED (OFF)
    (D): Slot 6: Port 6:  status = DISCONNECTED (OFF)
    (D): Slot 6: Port 7:  status = DISCONNECTED (OFF)
    (D): Slot 6: Port 8:  status = DISCONNECTED (OFF)
    ERROR: Failed to get IF interface.