| Title: | DEC TCP/IP Services for OpenVMS |
| Notice: | Note 2-SSB Kits, 3-FT Kits, 4-Patch Info, 7-QAR System |
| Moderator: | ucxaxp.ucx.lkg.dec.com::TIBBERT |
| Created: | Thu Nov 17 1994 |
| Last Modified: | Fri Jun 06 1997 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 5568 |
| Total number of notes: | 21492 |
Hi,
I have a customer who is seeing his system hang because of his token
ring interface.
Alpha 6.2-1H3, UCX 4.1.
Initially UCX did not see his PBXNP-AA PCI-Token Ring Adapter, IWA0.
I had him define this controller with the command:
UCX DEFINE COMMUNICATION_CONTROLLER IW /type=(cluster,token_ring)
/inter=w
Now, UCX could see his token ring interface.
However, his customer sent him directions that he needs to call his
interface TT0.
He did a command of:
DEFINE COMM IW /INTER=T /TYPE=(TOKEN,CLUSTER) ! he tried interface t and
! interface w
UCX SET INTERFACE tt0/host=peds
This is where his system hangs. He cannot CTRL/Y out of this and has
to reboot his system.
He tried the WT0 and TT0 naming conventions. He gets the same results
each time. Any ideas as to what is going on? Is this interface
supported by UCX?
Thanks,
-Rick
| T.R | Title | User | Personal Name | Date | Lines |
|---|---|---|---|---|---|
| 5157.1 | Any ideas? | CSC32::R_WILLIAMS | Mon Jan 27 1997 20:54 | 5 | |
Any ideas on troubleshooting this?
Thanks,
-Rick
| |||||
| 5157.2 | use lancp | LATINA::SOENGAS | MCS Madrid | Tue Jan 28 1997 10:52 | 13 |
Hi,
May you use $ mcr lancp and said 1)
show config and 2) show devices /param
From this utilitie you should see the token
ring interface with all the characteristics
(hardware address, speed, etc) , if you
don't see this the problem is hardware and
not software nor ucx problem.
Elsa Soengas
MCS Spain
| |||||