| I have just found an interesting problem:
Problem: While in edit mode in a group window, I accidentally
pressed the left mouse button quickly followed by the right
mouse button. This resulted in my being unable to draw any
more lines.
I tried turning Edit mode off and back on again; exiting
the group window and going back into it. The only way I
could get lines to draw again was to close down the C3
interface and restart it.
I also found a feature, and I am not sure if it was designed that way.
When in a group window, and edit mode is on, if you close the window,
the C3 line characteristics window remains displayed (however, you can
dismiss this window). Also, when you go back into the group window, Edit
mode is still on.
Phil
|
| Phil,
> Problem: While in edit mode in a group window, I accidentally
> pressed the left mouse button quickly followed by the right
> mouse button. This resulted in my being unable to draw any
> more lines.
>
> I tried turning Edit mode off and back on again; exiting
> the group window and going back into it. The only way I
> could get lines to draw again was to close down the C3
> interface and restart it.
I'll look into these problems.
>I also found a feature, and I am not sure if it was designed that way.
>When in a group window, and edit mode is on, if you close the window,
>the C3 line characteristics window remains displayed (however, you can
>dismiss this window). Also, when you go back into the group window, Edit
>mode is still on.
This is a 'featutre'. The line window remains displayed because you
might also be editing another window at the same time. I suppose to
be reallly cool, it would check to see that there are no other windows
being edited, and if so, then automatically dismiss the window.
|