Conference csc32::consolemanager

242.0. "Temp License expiring, need clarification on user license" by CSC32::J_WIELAND () Fri Apr 15 1994 13:42

Dear readers,

I have a customer that has a temp license on Polycenter Console Manager V1.0
for ultrix and he is now trying to load his 'purchased' 'user' licenses.
When he runs the IVP, (ie: setld -v), it fails...

If he does a lmf list (note: the 5th license is the temp one... and he has
only three remote systems configured at this time)

lmf> list
Product                   Status                     Users: Total      Active

POLY-CONSOLEMGR-USER      active                            4          0
POLY-CONSOLEMGR-USER      active, multiple                  4          0
POLY-CONSOLEMGR-USER      active, multiple                  4          0
POLY-CONSOLEMGR-USER      active, multiple                  4          0
POLY-CONSOLEMGR           disabled
LOTUS123-UR               active                            1          0
SOFTPC-UR                 active                            unlimited
DECNET-ULTRIX             active                            unlimited
ULTRIX                    active                            16         2
lmf> 

# lmf reset
Combine POLY-CONSOLEMGR-USER AL3-WM-94101-1303 with POLY-CONSOLEMGR-USER AL3-WM-
94101-1302
Combine POLY-CONSOLEMGR-USER AL3-WM-94101-1303 with POLY-CONSOLEMGR-USER AL3-WM-
94101-1301
Combine POLY-CONSOLEMGR-USER AL3-WM-94101-1303 with POLY-CONSOLEMGR-USER AL3-WM-
94101-1300
# setld -v DCRBASE100

Console Manager Base (DCRBASE100)
        POLYCENTER Console Manager Installation Verification Procedure

        Digital Equipment Corporation. 1993 All Rights Reserved


Checking for valid license....


   *************************    W A R N I N G    *************************
   *                                                                     *
   *  You have NOT registered the POLYCENTER Console Manager License !!  *
   *                                                                     *
   *  Load a POLYCENTER Console Manager PAK and then run this procedure  *
   *                                                                     *
   ***********************************************************************


Exiting IVP procedure
setld: ivp failed.
# 
Can anyone out there help us!!

Thanks in advance
John G. Wieland
Customer Support Center..

He has the wrong PAKS.

During the early field tests we had two PAK names for the product.

The Unlimited use PAK was POLY-CONSOLEMGR and the limited ( i.e. not 0
unit PAKS ) were POLY-CONSOLEMGR-USER.

This conflicted with normal practice so we were told to use POLY-CONSOLEMGR
for all PAKS and the unit numbers defined the numbers of connections.

So the long and the short of it is that those PAKS wont work!!!!


Chhers Simon....

    thanks for the quick response...
    
    john