Conference vaxuum::online_bookbuilding

158.0. "V1.2 installation problem" by BOOKIE::HEBERT (Cyberdyne Systems Model 101-A) Fri Jun 23 1989 18:05

    Hi,
 
    I just finished the installion of DOCUMENT V1.2, the new internal
    kit, and the CUP$ONLINE_TOOLS saveset on my cluster as prescribed in 
    note 64.7.
    
    The installation went without a hitch, except that when I tried to 
    build my book with the ONLINE.HANDBOOK destination I got an error
    that I really didn't expect:

%DOC-I-IDENT, VAX Document V1.2-A   2-JUN-1989 16:15:56.35
%DOC-F-PGFLQ_TOO_LOW, Process paging file quota too low, required value is 25000

    Is this a new requirement?  Since when does DOCUMENT require your
    PGFLQUO to be 25000?  Anyway, I set mine to 25k logged out and in
    again, and tried the build again.

    This time, it worked, but I got an internal error:

%DOC-I-IDENT, VAX Document V1.2-A   2-JUN-1989 16:15:56.35
[ T a g    T r a n s l a t i o n ]...
%TAG-I-DEFSLOADD, End of Loading of Tag Definitions
%TAG-I-LCL_MSG01, Using online bookbuilding tools, 20-MAR-89 baselevel
%TAG-E-INT_LOGIC, at tag <_INCR_SECTION_NUMBER> on line 9 in file   
USER1:[HEBERT.WORK]EPC_PREFACE.SDML   Internal error processing tag <NAME>
%TAG-E-INT_LOGIC, at tag <_INCR_SECTION_NUMBER> on line 15 in file   
USER1:[HEBERT.WORK]EPC_PREFACE.SDML   Internal error processing tag <NAME>
.
. (repeated for every header in every chapter in the book)
.
    And, since the headers didn't process, none of their symbols got
    defined either. So each time I referenced a section number, it failed
    and eventually the book build failed do to too many undefined references.

    Note that I did try processing the book with CUP_HANDBOOK and it
    worked just fine.  This seems to be just an ONLINE problem.  Also
    please note that this book processed correctly with the ONLINE.HANDBOOK
    destination yesterday when I was running DOCUMENT V1.1.
    
    Can anyone tell me what I did wrong in the installation?
    Yes, I ran SYS$STARTUP:DOC$STARTUP and DOC$INT_STARTUP on every
    node. And yes, I replaced the DCL tables and merged DOC$INT_DESIGNS.DAT
    file with my DOC$DESIGNS.DAT.
    
    thanks,
    
    --Jeff Hebert

    Install the june baselevel of the online bookbuilding tools and
    everything will be compatible. Note 64 has all the information you
    need.
    
    Mike

    The Fine (installation) Manual documents the need for additional
    PGFLQUO.  So do the internal installation notes.
    
    Mark

    Well, that's what I get for looking at the Release Notes and not
    the Installation Guide(s).  
    
    It was using the wrong baselevel because I had restored
    CUP$ONLINE_TOOLS.SAV to the wrong place (I left out the "..." on
    the BACKUP destination).
                      
    thanks for your help,
    
    Jeff Hebert