| Title: | *OLD* ALL-IN-1 (tm) Support Conference |
| Notice: | Closed - See Note 4331.l to move to IOSG::ALL-IN-1 |
| Moderator: | IOSG::PYE |
| Created: | Thu Jan 30 1992 |
| Last Modified: | Tue Jan 23 1996 |
| Last Successful Update: | Fri Jun 06 1997 |
| Number of topics: | 4343 |
| Total number of notes: | 18308 |
is it wierd or what?
a user is not able to print anything that is a mail message she
created. i've only been able to test the created folder so far, but
if i try to print a mail message that is in the created folder, it will
not print. the burst/flag/header pages ar set to N, if i change them
to Y, they print, but not the document.
this user can print private documents ok, and prints ok from VMS.
other ALL-In-1 users use this printer with no problems. the system has
not been re-booted recently and there is nothing special with this
users account.
ALL-IN-1 2.4, VMS 5.4-3 no patches. the printer is an LN03.
Actually, this user has this problem with other LN03 printers on her
network.
Any ideas? Ann
| T.R | Title | User | Personal Name | Date | Lines |
|---|---|---|---|---|---|
| 1143.1 | What editor? | IOSG::NEWLAND | Richard Newland, IOSG, REO1-D/4A | Wed Jul 29 1992 20:05 | 6 |
What editor is the user using to create the messages? If the editor is changed does it make any difference? Richard | |||||
| 1143.2 | Check the KOA$PRINT_SHARE:LN03.PRA is it 8-bit esc seq ? | GIDDAY::SETHI | Man from Downunder | Thu Jul 30 1992 00:15 | 31 |
G'day Ann Oooppps !!!,
>Actually, this user has this problem with other LN03 printers on her
>network.
Under Version 2.4 the "wrong" KOA$PRINT_SHARE:LN03.PRA file was sent
out, it contained 8-bit ESC sequences rather than the 7-Bit ESC
sequences. The LN03's worked okay to a large extent, however at times
such things as formfeed's did not work.
To differentiate between an 8-bit table and a 7-bit table
<DCS> = <ESC>P
<ST> = <ESC>\
<CSI> = <ESC>[
For further information see Stars article "7-bits Equivalents for 8-bits
escape seq. in .PRA tables". The printer tables for ALL-IN-1 Version 3.0
are 7-bit. Make a copy of the LN03.PRA and change the 8-bit's to
7-bit's and setup a printer within ALL-IN-1 using the 7-bit table and
see what happens. There are other articles in Stars that deal with
this problem. I solved a problem at a customer site by changing to
7-bit escape seq.
The only suggestion I can make about the user's printing problems is to
do a $ALLIN1/NOCUSTOMISE and see what happens.
Good luck
Sunil
| |||||