|  |     
    
    To convert to FWC varies with the engine- some ( such as my OMC I/O),
    don't permit the exhaust manifolds to be fresh water cooled, only the
    block- the newer manifold designs can be, but the exhaust elbows are
    almost always Salt Water cooled.
    
     Using a small block chevy such as mercruiser or OMC- you need a few
    major peices:
    
     Heat exchanger with Volume tank
     Raw water pump
     Varioyus mounting brackets
     Hoses,clamps,fittings
     Oil cooler (optional)
     transmission oil cooler( not used on I/O)
    
     In simple terms, FWC sets up your engine to be cooled just like
    it's automotove relatives, except that a water/Salt water heat
    exchanger instead of a water/air exchanger(aka radiator) is used.
    The exhaust manifolds can also be cooled with Fresh watrer( depending
    upon design), but this increases the load on the heat exchanger and
    requires a larger heat exchanger.The crankcase oil can also be cooled
    with either fresh or salt water.
    
     The best sourcde of info is the manufacturers- Sen-Dure industries 
    has kits for just about any engine- I don't have the adress handy-
    If you are interested, drop me a not at biznis::Cadmus
    
    Most of the kits run $400-$600 and include all the parts except the oil
    coolers. I declined to do my engine since the original engine lasted 15
    years in salt ater and simply wore out. TYhe design of the manifolds on
    my engine would not allow FWC of the exhaust manifolds, so I decided to
    forget the manner- Sen Dure walso did not recommend adding FWC on an 
    engine that had been usedf for a couple of years.
    
     Hope this helps
    
    Dick
     
     
    
     
 | 
|  |     This has been covered under "Sailing" notes, .  What it all boils down
    into, is that adding the fwc before adding salt (water) will usually
    double the life of the engine.  Sendure is one of the most
    knowledgeable fwc cooling manufacturers.  They are located on Long
    Island. With the cost of replacement engines so high, I would recommend
    adding fwc on any inboard engine with at least a couple of years left 
    on it.  In addition, I designed and built fwc's for my twin Chris
    engines a few years ago. Sendure can tell you all you need to know,
    but if you have any questions, add to this note.
 |